Use the following steps to edit an existing label image within the Digi system:

  • Access Digi
    • Sign into Ninjaone
    • Enter EWG011SV-DIGI
    • Use VNC to remote into desired Digi system
  • Edit PLU
    • Main Menu

    • User Log in/out

    • Engineer > grobtech > OK

    • Programming Menu

    • PLU Editor

    • Edit Existing Record

    • Select PLU > OK

    • Under Setup tab (default) > Labellers > Edit 

    • Click and drag over design elements in right side column

    • Hover cursor over selected elements until it turns into 4 arrows > Left click and drag 

 >

    • Close Format Editor > Yes to save

    • Select Exit or OK to exit PLU Editor

    • Yes to save changes

    • Exit PLU Editor

    • Exit > Exit

  • Test edited PLU
    • Select PLU number box under PLU No.

    • Select PLU being edited > OK

Note: Always reselect PLU after editing. Existing selected PLU will be using old data

    • Place weight on packoff scale > print label > accept adjustment or make more as needed
    • Repeat "Edit PLU" section steps until label test is acceptable
  •  Sign Out
    • Main Menu

  • User Log in/out
  • Log Out > OK

  • Exit